Panther 55-0135 Trim and Tilt Model 135
Make your day on the water just a bit more enjoyable with out straining your muscles trying to raise and lower an outboard motor that is not equipped with trim and tilt. A simple convenience with major results. The model 135 is the perfect option for older outboard motors with bad hydraulic trim and tilts, when repair costs are prohibitively expensive.
The heavy duty bracket is designed for outboards up to 135HP or 350 pounds and it maximizes lifting power (even greater than the outboards tilt range), and it also allows for increased tuck-under to get heavy boats on plane quickly. Adapts to clamp on or bolt-through outboards.
With a motor rating of up to 135 HP or 350 lbs., virtually any trim and tilt need can be met by installing the Model 135 on your transom.
A rugged 12 volt powered actuator moves the motor plate up and down, allowing the user to easily position the motor with the remote control tethered to a 12 foot cable.
Made of 713 cast aluminum and protected with durable black powder coat, the 135 has an overall weight of 31 lbs.
To provide adequate support for your Panther bracket, the Transom side of the bracket must be 100% covered by the boat’s transom.
Motor Plate Dimension
Height 11 inches [27.94 cm]
Width 14 1/4 inches [31.2 cm]
Bolt Pattern
B.I.A.
Transom Plate Dimension
Height 14 inches [35.56 cm]
Width 15 inches [38.1 cm]
Bolt Pattern
B.I.A.
